King Canopy G10208 Manuel d'instructions

Naviguer en ligne ou télécharger Manuel d'instructions pour Non King Canopy G10208. King Canopy G10208 Instructions / Assembly Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 10
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Dome Garage 10 ft x 20 ft
10 ft Wide x 20 ft Deep x
8 ft Center Height
King Canopy Item # G10208
With 10 Legs, 1 Piece Cover with Side Walls, 1 Zippered End Wall,
1 Solid End Wall, Elastic Ball Straps, Foot Pads and Anchors.
WARNING:
Keep all ame and heat sources
away from this tent fabric. Meets
the ammability requirements of
CPAI-84 Section 6 and NFPA-701.
It is not re proof. The fabric will burn if
left in continuous contact with
any ame source.
Distributed by:
PIC America, LTD.
1730 Five Points Lane • Fuquay-Varina, NC 27526
1-800-800-6296 • www.kingcanopy.com
Vue de la page 0
1 2 3 4 5 6 7 8 9 10

Résumé du contenu

Page 1 - King Canopy Item # G10208

Dome Garage 10 ft x 20 ft 10 ft Wide x 20 ft Deep x 8 ft Center HeightKing Canopy Item # G10208With 10 Legs, 1 Piece Cover with Si

Page 2 - PARTS LIST

PRODUCT INFORMATIONDefective PartsWe try our best to eliminate any defective parts that are shipped with our products. If, however, you should nd a

Page 3 - FRAME ASSEMBLY

PARTS LISTFOOT15PC-T (4) 2-way Corner Foot Pads FOOT15PC-X (6) 3-way Center Foot Pads3W13PC-T (10) 3-way Connectors (ends)4W13PC-X (15) 4-way Conn

Page 4

FRAME ASSEMBLYLay parts out as shown in Diagram A below. Note: The 58 inch straight pipe form the length of the frame.The 33.5 inch straight pipe are

Page 5 - COVER & LEGS ASSEMBLY

FRAME ASSEMBLYAfter assembling the rst full length section of roof, (See Diagram C-1) use the rope enclosed to hold frame together by tying frame fro

Page 6

COVER & LEGS ASSEMBLYRemove cover from plastic bag and unfold. Next fold half the cover over the other half with the white side out. Match the cor

Page 7

Once you have secured top to curved section of frame, you may now nish frame assembly. Assemble the remaining frame on each side using the 33.5´´ pip

Page 8 - ANCHORING YOUR UNIT

To complete your canopy, secure the top down each side on the bottom pipe and around each end with ball straps. (See Diagram N)Add the canopy en

Page 9

ANCHORING YOUR UNITThis canopy is designed for use as a temporary structure. After assembly, the canopy MUST BE securely anchored to the ground to pr

Page 10 - PRODUCT INFORMATION

IMPORTANT NOTICE: PLEASE READ CAREFULLYWe are condent that you will be completely satised with your King Canopy unit. Please take a moment to read

Commentaires sur ces manuels

Pas de commentaire