King Canopy G10208 Manuel d'instructions télécharger pdf (Page 8)

ANCHORING YOUR UNIT

This canopy is designed for use as a temporary structure. After assembly, the canopy MUST BE

securely anchored to the ground to prevent damage from winds. Your canopy will act like a

kite in the wind if not properly and securely anchored to the ground. Severe winds will cause

the frame to twist and unanchored legs will fall, thereby collapsing the canopy. If severe winds

are expected, you must remove the cover from the frame to prevent damage.

We recommend anchoring your canopy at each corner foot

and center foot on each side. Screw anchor into ground next

to canopy foot using a large screw driver as seen in Diagram

A. Looping the cable through the anchor eye will keep it

out of the way while turning. Tilting the anchor slightly will

help the anchor to cut into the ground. Apply downward

pressure while turning the anchor into the ground. Leave

approximately three inches of anchor out of the ground.

Unloop the cable from the anchor eye and slide the clamp

onto cable. Run cable around the pipe, (See Diagram B) and

then back through the clamp as seen in Diagram C. Pull the

cable as tight as possible through the clamp. Hold the cable

and tighten clamp with a 5/8 inch wrench or some type of

adjustable wrench.

When you have tightened the clamp and satised that the

cable will not slip, you may tighten the cable more by turning

the anchor further in the ground as seen in Diagram D.

If you have further questions call our customer service

department toll free at 1-800-800-6296

Diagram A

Diagram B

Diagram C

Diagram D

Parts Enclosed> 6-screw-in anchors with cable and clamp attached

(Tools needed = 5/8 inch wrench and large heavy-duty screw driver)

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

King Canopy G10208 Manuel d'instructions Page 8